Which hub software is the best? Where can I find script XXX? Discuss it here...(no, this is not for advertising your hub...)
Moderator: Moderators
-
Robin
- Posts: 10
- Joined: 2003-07-11 15:39
Post
by Robin » 2003-07-11 15:49
Help
My hub is down!
i am getin this messages on start up
Run-time error `339`:
Please Help!!!
-
BSOD2600
- Forum Moderator
- Posts: 503
- Joined: 2003-01-27 18:47
- Location: USA
-
Contact:
Post
by BSOD2600 » 2003-07-11 16:02
Its a problem with a script....disable them all and startup. Then enable them one by one and see which one causes the problem
-
Robin
- Posts: 10
- Joined: 2003-07-11 15:39
Post
by Robin » 2003-07-11 16:14
nope this si not the problem
-
Robin
- Posts: 10
- Joined: 2003-07-11 15:39
Post
by Robin » 2003-07-12 13:11
Run-time error`339`:
Component`DCSysTray.ocx` or one of its dependencies not correctly registered: a file is missing or invalid
Please help
-
Tang
- Posts: 16
- Joined: 2003-02-21 04:56
Post
by Tang » 2003-07-12 13:33
make a backup of your hub, re-install it, and then copy your hub back over the new install. It's because a file wasn't properly registered or was deleted.
-
RiPOFF
- Posts: 8
- Joined: 2003-06-13 12:33
Post
by RiPOFF » 2003-07-13 01:50
I dont Get It THere Is A Dc Hub Ver3? Where Can I Get IT?
-
synapz
- Posts: 18
- Joined: 2003-01-03 13:04
- Location: Sweden
-
Contact:
Post
by synapz » 2003-07-13 02:51
The problem is that you need to install the NMDC client because it contains the missing component. The named component does not exist with in the hub software installation so you need to install both the client and the hub.
V3 is the normal hub software...
Just another silly hub owner
-
Robin
- Posts: 10
- Joined: 2003-07-11 15:39
Post
by Robin » 2003-07-13 06:29
Nope , stil not working !
-
Tang
- Posts: 16
- Joined: 2003-02-21 04:56
Post
by Tang » 2003-07-13 07:40
Ah, thanks synapz, I should have thought of that.
Robin: Maybe reading the documentation would help??