when send $Hello, $MyInfo ...

Freak.2k · Post by **Freak.2k** » 2004-10-11 12:52

Hey,

When do I have to send commands like Hello,MyInfo,GetNickList....
I tried it with the original DC Hub. After I have sent my Password, the comes nothing beside of "<Hub> access granted".
Wiki says, that the $LogedIn command is sent after I've loged in and I am a op.
I'm an op, but this command doesn't come.
Is this different between the hubs?

thx

-------------------------------------------------------
Excuse my english, I'm from Germany

joakim_tosteberg · Post by **joakim_tosteberg** » 2004-10-11 13:19

Check out http://wza.digitalbrains.com/DC/doc/Cli ... Login.html and see if it helps you, that site is the one that describes the initial handshake between the hyb and the client best I think.

Freak.2k · Post by **Freak.2k** » 2004-10-12 09:08

Yes I know this!
when I log in as an user, I get the hello message,
but when I log in as an op, I get no LogedIn Message....

Todi · Post by **Todi** » 2004-10-12 10:29

What hubsoft are you logging into? Are you sure you are an OP? Do you get the $NickList and stuff after that, so you're sure the login works?

Freak.2k · Post by **Freak.2k** » 2004-10-12 10:43

Im using the original DC Hub
After I've logged in as an op, I get only a "<Hub> Access granted"

[NL]Pur · Post by **[NL]Pur** » 2004-10-24 05:26

with what tool are you looking at the traffic the hub is sending towards you?

Post by **GargoyleMT** » 2004-10-24 16:12

[NL]Pur wrote:with what tool are you looking at the traffic the hub is sending towards you?

Ethereal is free: http://www.ethereal.com/

[NL]Pur · Post by **[NL]Pur** » 2004-10-25 04:12

i know that, but does freak know that,

After I've logged in as an op, I get only a "<Hub> Access granted"

this doesn't seem like much protocol has been captured..