when send $Hello, $MyInfo ...

Technical discussion about the NMDC and <a href="http://dcpp.net/ADC.html">ADC</A> protocol. The NMDC protocol is documented in the <a href="http://dcpp.net/wiki/">Wiki</a>, so feel free to refer to it.

Moderator: Moderators

Locked
Freak.2k
Posts: 8
Joined: 2004-10-04 14:00

when send $Hello, $MyInfo ...

Post by Freak.2k » 2004-10-11 12:52

Hey,

When do I have to send commands like Hello,MyInfo,GetNickList....
I tried it with the original DC Hub. After I have sent my Password, the comes nothing beside of "<Hub> access granted".
Wiki says, that the $LogedIn command is sent after I've loged in and I am a op.
I'm an op, but this command doesn't come.
Is this different between the hubs?

thx

-------------------------------------------------------
Excuse my english, I'm from Germany :)

joakim_tosteberg
Forum Moderator
Posts: 587
Joined: 2003-05-07 02:38
Location: Sweden, Linkoping

Post by joakim_tosteberg » 2004-10-11 13:19

Check out http://wza.digitalbrains.com/DC/doc/Cli ... Login.html and see if it helps you, that site is the one that describes the initial handshake between the hyb and the client best I think.

Freak.2k
Posts: 8
Joined: 2004-10-04 14:00

Post by Freak.2k » 2004-10-12 09:08

Yes I know this!
when I log in as an user, I get the hello message,
but when I log in as an op, I get no LogedIn Message....
---------------------------------------------
Excuse my english, I'm from Germany

Todi
Forum Moderator
Posts: 699
Joined: 2003-03-04 12:16
Contact:

Post by Todi » 2004-10-12 10:29

What hubsoft are you logging into? Are you sure you are an OP? Do you get the $NickList and stuff after that, so you're sure the login works?

Freak.2k
Posts: 8
Joined: 2004-10-04 14:00

Post by Freak.2k » 2004-10-12 10:43

Im using the original DC Hub
After I've logged in as an op, I get only a "<Hub> Access granted"
---------------------------------------------
Excuse my english, I'm from Germany

[NL]Pur
Programmer
Posts: 66
Joined: 2004-07-21 14:32

Post by [NL]Pur » 2004-10-24 05:26

with what tool are you looking at the traffic the hub is sending towards you?

GargoyleMT
DC++ Contributor
Posts: 3212
Joined: 2003-01-07 21:46
Location: .pa.us

Post by GargoyleMT » 2004-10-24 16:12

[NL]Pur wrote:with what tool are you looking at the traffic the hub is sending towards you?

Ethereal is free: http://www.ethereal.com/

[NL]Pur
Programmer
Posts: 66
Joined: 2004-07-21 14:32

Post by [NL]Pur » 2004-10-25 04:12

i know that, but does freak know that,

After I've logged in as an op, I get only a "<Hub> Access granted"


this doesn't seem like much protocol has been captured..

Locked