Active IP settings for different hubs

Astro-g · Post by **Astro-g** » 2004-04-21 08:17

I use DC on a small network, and that network is connected to the internet by a NAT router. I use the routers external address, and port forwarding to make this work properly for external hubs, but now any internal traffic gets sent to the routers external address.

There needs to be a way to set up the active IP and port on a per-hub basis.

BSOD2600 · Post by **BSOD2600** » 2004-04-21 09:30

I highly doubt this will happen since its currently a global thing. Just run two installs of DC++... on for the internet and the other for the LAN.